P5
OSRAM Powertronic PT-FIT 70/220…240 S Electronic Ballast
OSRAM Powertronic PT-FIT 70/220…240 S Electronic Ballast
SKU SKU:4008321386649
หมดสต็อก
แบ่งปัน
Technical Details
- Optimized cost/benefit factor
- Compact dimensions and low weight for small luminaire designs
- Automatic safety shutdown of lamps in the event of a defect or at end of life (EOL)
- Shop lighting
- Health and fitness areas (in luminaires with protection class IP66 or higher)
- Effect and accent lighting
Safety advice
Ballast losses and lamp heat radiation can lead to heat accumulation in a completely closed case. Therefore it is necessary to ensure that the temperature at the measuring point t of the ECG does not exceed the maximum value.
Attention!
For safety reasons disconnect the device before replacing the lamp!
Electrical data
Lamp wattage
73 W
Line current
0.36 A
Ignition voltage
4.5 kVp
Operating frequency
0.200…0.240 kHz
System wattage
80.00 W
Efficiency in full load
92 %
Input voltage AC
198…264 V
Nominal voltage
220…240 V
Mains frequency
50…60 Hz
Power factor λ
0.95
Inrush current
45 A
Max. ECG no. on circuit breaker 10 A (B)
7
Max. ECG no. on circuit breaker 16 A (B)
13
Max. no. of ECGs on 16A MCB with EBN-OS
32
Protective conductor current
0.3 mA
U-OUT (working voltage)
250 V
Max. working voltage between LH and LL
250 V
Max. working voltage betw. LL/LH & earth
250 V
Max. capacitance of wire ECG/lamp
120 pF
Dimensions & weight
Length
110.0 mm
Width
75.0 mm
Height
30.0 mm
Mounting hole spacing, length
99.0 mm
Mounting hole spacing, width
64.0 mm
Cable cross-section, input side
0.5…1.0 / 0.5…1.5 mm²
Cable cross-section, output side
0.5…1.0 / 0.5…1.5 mm²
Wire preparation length, input side
8.5…9.5 mm
Wire preparation length, output side
8.5…9.5 mm
Product weight
250.00 g
Colors & materials
Casing material
Metal
Temperatures & operating conditions
Ambient temperature range
-15…+55 °C
Maximum temperature at tc test point
85 °C
Lifespan
ECG lifetime
30000 h
Additional product data
Design / version
Built-in unit
Suitable for lamp power (1 lamp)
70 W
Capabilities
Max. cable length to lamp/LED module
1.5 m
Overheating protection
Power reduction and switch off at T > 85 °C at the tc point
ECG reset time
> 0.5 s
Dimmable
No
Restriction on ignition time
20 min
Suitable for fixtures with prot. class
I
Intended for no-load operation
No
Certificates & standards
Approval marks – approval
VDE / VDE-EMC / EAC / C-Tick
Type of protection
IP20
EEI – Energy Label
A2
Standards
Acc. to EN 61347-2-12/Acc. to EN 55015/Acc. to EN 61000-3-2/Acc. to EN 61547
Logistical data
Commodity code
850410809000